Before installing your new Chinese Diesel Heater, you should determine where to place it. You can place it on the floor of your van. Make sure that you do not place it close to an outlet. You will need to use a vacuum cleaner to remove any debris and dirt that may be present in the tank. You can also install an additional in-line filter to prevent dirt and debris from entering the tank. You will need to install a control unit that is located outside of the vehicle. A wireless one is available as an extra option.

Once you have the heater, you need to connect the fuel tank and heater. You will need to install the pump in the distance between the fuel tank and heater. Once you have all the components, you can begin to install the Chinese Diesel. Once the installation is complete, you will need to fill it with water. You may also need to clean the unit before you use it. Once you have the tank and the heater installed, you can use the fuel and then use it to warm up the van.

A new Chinese Diesel Heater comes with a muffler that connects the fuel tank, pump, and filter. A plastic fuel line slides into the muffler and is secured by clips. Once you have the fuel line attached, you need to connect the heater to the pump’s output. After that, you need to attach the plastic fuel line to the underside of the Chinese diesel heater.

The Chinese Diesel heater has made huge progress and now has a massive following in the camper van and diesel heating communities. For about $125 to $175, the heaters are comparable to European versions and have a thriving grassroots community. The best part is that you don’t need to drive a diesel vehicle to install a Chinese Diesel heater. Many of them come with a mini gas tank and have easy-to-follow instructions.

To install a Chinese Diesel heater, you will need a few tools. Firstly, you will need a tube connecting the fuel tank to the Chinese diesel heater. Then, you will need to connect a plastic fuel line to the pump’s output. The plastic pipe should be fitted over the fuel filter. To install a Chinese Diesel heater, you must make sure that the tank is at the same level as the fuel line.

Then, you need to connect a rubber fuel pipe from the fuel tank to the heater. The heater should be connected to the fuel tank. The pump is connected to the fuel tank. The fuel pipe should be attached to the filter. Next, you should attach the Chinese diesel heater to the fuel intake. Then, you can plug it in and start using it. After installing the Chinese Diesel Heater, you should check the fuel level. Once it is at the right level, you will be able to turn on the heating unit.

Once you have your new Chinese Diesel heater, you should put it in place. After connecting it to the fuel tank, you should also put a small piece of pipe on the bottom of the heater to connect to the pump’s inlet. The other tube should pass through the hole in the floor of your van and connect to the underside of the Chinese diesel heater. After that, you should start using it.

After preparing the fuel tank, you should connect the small tube to the pump and filter. Then, the longer tube should connect the pump to the output of the heater. Ensure that the heater is placed at a distance that will prevent it from touching the fuel tank. This will prevent it from leaking. In addition to the filter and the pump, you should also take into consideration the distance between the two parts.

Once you have installed the pump, you need to attach the small piece of tube to the inlet of the heater. Once this is done, you should connect the long length of tube to the pump’s output. Then, install the Chinese diesel heater on the top of the fuel tank. Then, place the fuel tank on the ground. It will be level with the ground. It is important to have the heater mounted in a good position for proper air circulation.